Page 1 of 1
Update Calibration Prompt
Posted: Wed Nov 14, 2007 7:45 pm
by EMk20a2
When I plug my laptop in to datalog I get a prompt to update my calibration. I am assuming that this means the calibration was created with a older version than I have on my laptop. I typically close the window and datalog because I don't know how to update the calibration. I was just wondering if this was bad to do, if it could screw up my calibration?
Posted: Thu Nov 15, 2007 9:02 am
by Hondata
Do you have the calibration saved on the laptop? If you do, just load it and upload it.
Posted: Thu Nov 15, 2007 5:21 pm
by EMk20a2
that is the thing I don't it is on the shop's that tuned my car, so now what do I do? Is it messing anything up with the car by not?
Posted: Fri Nov 16, 2007 9:16 am
by Hondata
Ask your tuner for the calibration. If you can't get it, then download from the ECU.