Hondata

In the past week I've developed the following problem. Under WOT I think the car is popping into limp mode. The problem only last a second or two, the check engine light flashes on then off (code not stored), then the car recovers and runs fine. I was able to datalog the sequence and have attached. Any ideas on what's going on would be appreciated
Thanks, Bob

You're hitting a boost cut.

I've got a supercherged Type R and am using the stock map. Is there any harm in disabling the boost cut or would it be better to install a 3 bar map?
Thanks

You can disable the boost cut, but without knowing how much boost you are making it is impossible to say if you need a 3bar map sensor.

The help files indicate that 10.5 psi is the max the stock map can reliably measure. When I set them above this level I get the warning about exceeding this value. I believe on a cold day I may be seeing ~11psi. Will I have any problems running this level of boost w/the stock map? Being supercharged I don't need to worry about higher levels than this.
Thanks

you will probably be ok as long as you tune it properly at the max boost level and disable the boost cut.