Page 1 of 1
S300 Fresh No run solid red LED on USB coms port
Posted: Sun Oct 28, 2007 3:24 pm
by JDMCRX
Hey guys.
Installed the S300 and all the jumpers and sockets in the the right locations. Problem im having is 1 Im getting a solid red light and the car will not run.
I can see the ECU online in the left corner of the HD screen. I can upload maps onto the ecu.
But the ecu is still in red and i can not see any sensors when i log into the HD screens. Anyone????
This is a EG coupe and a PR4 Ecu and S300
Posted: Sun Oct 28, 2007 8:55 pm
by Hondata
It's the socketing. Double check each pin for cold joints, bridged joints or any lifted tracks.
Posted: Mon Oct 29, 2007 8:52 am
by JDMCRX
Yeah i did that already checked each sodered joint. im gonna re do them this weekend any try it again. Cause we plugged the ECU in and went for a drive and it ran fine.
Red lights means what tho exactly?
Posted: Mon Oct 29, 2007 9:36 am
by Hondata
Red light means that the s300 cannot communicate with the ECU. If the car runs ok, then check that J1 is in place.
Posted: Thu Nov 01, 2007 2:20 pm
by B18c1turboedeg
Im having the same problem. I tought it was the ecu, i took my s300 out and put it in another ecu, same problem. I then installed a friends s300 in my ecu and it worked perfectly. Something is wrong i just cant figure out what it is any suggestions?
Posted: Mon Nov 05, 2007 11:52 am
by Spunkster
What versio of software are you using? What happens when you go to File, New and upload a new calibration to the ecu?
Posted: Tue Nov 06, 2007 5:40 am
by B18c1turboedeg
Spunkster wrote:What versio of software are you using? What happens when you go to File, New and upload a new calibration to the ecu?
For me, it does the same thing. Im not 100% sure what version im running,but i will install the new one this week and see if it works.
But i know we put the s300 in another ecu and car and tried to get tuned and it wouldnt work then eighter, any suggestions?