Probably a silly question- S300 Analog input

PurpleCivicTurbo · Post by **PurpleCivicTurbo** » Wed Oct 03, 2007 8:53 am

I know i have seen information relating to the analog inputs before- but i cant seem to find it anywhere- can someone point me in the right direction.

I need to know what pins the analog inputs are, whether these are "analog1 and analog 2" in Smanager, what needs to be done so these inputs can be used and what voltage the sensor must provide (0-5v or 0-12v)

Sorry if these is covered elsewhere, but i was unable to locate, also i wasnt sure whether my entire question was covered in the origional write-up

Thanks in advance!!

Post by **Spunkster** » Wed Oct 03, 2007 9:14 am

In Smanager go to Help, Contents, and search for "analog".

PurpleCivicTurbo · Post by **PurpleCivicTurbo** » Wed Oct 03, 2007 12:52 pm

Thanks very much- never for a second occurred to me to check in smanager.

Apologies again!