Page 1 of 1
Which map sensor is recommended for about 35+ lbs of boost
Posted: Wed Sep 19, 2007 8:25 am
by thudreem
I have the GM 3 bar currently at 26 lbs of boost but I want to increase the boost. Should I go with a motorola 4 bar, or a AEM 3.5 bar or 5 bar. I want to keep a boost cut that is why I need to change from the GM 3 bar.
What works best for the s300?
Thanks,
Sean
Posted: Wed Sep 19, 2007 8:44 am
by WickedCivicNY
AEM 5 Bar
Posted: Wed Sep 19, 2007 8:49 am
by thudreem
WickedCivicNY wrote:AEM 5 Bar
If I do not think I will go over 37lbs should I go with the 5 bar?
Also, how is the resolution on that sensor?
Posted: Fri Sep 21, 2007 9:03 am
by planetspeed
This is where "More is better" works..If you do plan to boost higher, a 5bar is the way to go..
Posted: Sat Sep 22, 2007 8:19 pm
by boostedcivicsir
do it once and be done.
Posted: Sun Oct 07, 2007 1:35 am
by SFWD 1934
boostedcivicsir wrote:do it once and be done.
I agree. Not to mention, you can alter all the load points to what you want. So you can have the 5 bar with PSI load points that go only to 35 PSI as opposed to 60 PSI.
Jason
Posted: Fri Oct 12, 2007 10:05 am
by thudreem
SFWD 1934 wrote:boostedcivicsir wrote:do it once and be done.
I agree. Not to mention, you can alter all the load points to what you want. So you can have the 5 bar with PSI load points that go only to 35 PSI as opposed to 60 PSI.
Jason
That is a very good point!! I went with the AEM 3.5 bar and did exactly what you said..!!
on a side note, do you run an ignition in your car and if so check out this thread please:
http://hondata.net/forum/viewtopic.php?t=7081