Base calibration help needed, d-series dohc turbo hybrid
Posted: Wed Sep 19, 2007 2:21 am
Does anyone here have a base map calibration I can use to start off with?
The calibrations i could probably start with are;
P74 B18b non-vtec
D16 supercharged with 440cc's
Greddy B16a?
But I was hoping someone else here has used an S300 to tune their non-vtec d-series turbo and wouldn't mind sharing the file.
The thing is my engine is pretty much a one-off, it's a dohc ZC head modified to fit a SOHC D-series block with PM6 pistons which as far as i know has never been done before successfully.
It's 8.3:1 compression and i am running 560cc injectors and a T25 turbo.
Because it's non-vtec I only need the low cam maps but with the 560cc injectors and no ICAV it's going to be a hard task writing a base calibration from scratch, especially as I'm new to this.
Can someone please lend me a file to start off with?
Regards,
Mike
The calibrations i could probably start with are;
P74 B18b non-vtec
D16 supercharged with 440cc's
Greddy B16a?
But I was hoping someone else here has used an S300 to tune their non-vtec d-series turbo and wouldn't mind sharing the file.
The thing is my engine is pretty much a one-off, it's a dohc ZC head modified to fit a SOHC D-series block with PM6 pistons which as far as i know has never been done before successfully.
It's 8.3:1 compression and i am running 560cc injectors and a T25 turbo.
Because it's non-vtec I only need the low cam maps but with the 560cc injectors and no ICAV it's going to be a hard task writing a base calibration from scratch, especially as I'm new to this.
Can someone please lend me a file to start off with?
Regards,
Mike