Page 1 of 1
Two Step With Kpro
Posted: Mon Jul 23, 2007 7:32 am
by jjcr2011
Hello. I have a Swap of K24 in Civic 92. I need to put the two step. What cables in the Kpro i need to cut to put the sensor. And the program use the launch revolution limiter???
Please help me
Thanks
Posted: Mon Jul 23, 2007 10:25 am
by Spunkster
There is no 2-step in Kmanager. There is a standing rev-limit that can be set in Parameters under the Rev Limits tab.
Posted: Mon Jul 23, 2007 7:50 pm
by jjcr2011
Ok The sensor of clutch? Whats cables i need to put in the Wiring Harness for the rev limiter function.
Posted: Tue Jul 24, 2007 9:16 am
by Spunkster
There is no wiring for this, It does not use a clutch switch. Please look at the Paramaters under Rev Limits.
Posted: Wed Jul 25, 2007 9:43 am
by jjcr2011
Ok. What form i use the rev limiter. I set 5500 and not work. The engine to this revolution no set bum bum bum bum. You understand.
Posted: Wed Jul 25, 2007 3:11 pm
by Spunkster
post a datalog and calibration
Posted: Fri Jul 27, 2007 9:42 pm
by jjcr2011
This is my calibration. Please help me
Thanks
Posted: Mon Jul 30, 2007 9:56 am
by Spunkster
Can you please post a datalog showing the problem, as I do not understand your description of the problem.