Hondata

Posted: **Wed Jul 18, 2007 8:35 pm**

1. Do i need to run the sensor that is located on the intake arm? will it mess with my datalogging? (a/f, MAP readings, all that good stuff). If i dont how do i turn it off? will it mess with my tune?

2. I lost my Hondata K-manager CD, is it possibly to update software without it? is it possibly to use the K-manager on a different laptop without the CD? is there a download where i can install the USB drivers, and k-manager?

i know there are a lot of questions but thank you for your time!

Posted: **Thu Jul 19, 2007 9:25 am**

Which sensor do you mean?

The software can be download here http://hondata.net/updates/?app=KManage ... n=download

Posted: **Thu Jul 19, 2007 9:31 am**

If you mean the intake air temp sensor, you cannot eliminate it. It must be used.

Posted: **Fri Jul 20, 2007 9:52 am**

Hondata wrote:Which sensor do you mean?

The software can be download here http://hondata.net/updates/?app=KManage ... n=download

the sensor that is located on the intake arm, little black sensor, it can be taken out by a clip. and is there anyway to install usb drivers without the CD?

Posted: **Fri Jul 20, 2007 10:58 am**

in Kmanager, go to Help, click on contents, then go to installation and follow the installation instructions.

Also make sure you download the most recent version of Kmanager form the Hondata website.

Hondata

A couple of questions here please help!

A couple of questions here please help!