Solid Cel, Solid LED.

fu@k_awd · Post by **fu@k_awd** » Thu Jun 21, 2007 12:54 pm

Like the title states. just installed a edelbrock intake manifold and after the install i get a solid CEL light, the light on the s200 box is also solid.
car starts and runs. idle is high and fluxes but no rev limit or anything.
Can i check the code without the datalogging option?

Post by **Spunkster** » Thu Jun 21, 2007 1:09 pm

This should help: http://www.hondata.com/techecucodes.html

fu@k_awd · Post by **fu@k_awd** » Thu Jun 21, 2007 2:25 pm

I have not been able to find the 2 pin to short it out in this car.
could it not be there at all or does it have to be.

Post by **Spunkster** » Thu Jun 21, 2007 4:09 pm

it should be there