Page 1 of 1
Tuning for VTEC Killer Cams and ITBs
Posted: Fri Jun 15, 2007 9:10 am
by aahill69
I'm installing VTEC KC and ITB's all at once. Which of the tables are used for tuning, the LO or the HI? Do you have to mix values from both tables into one?
Posted: Fri Jun 15, 2007 10:35 am
by Spunkster
If you are disabling vtec and VTC then you will just be using the low cam settings.
Posted: Mon Jun 25, 2007 9:58 am
by aahill69
What about tuning over 8k RPMs. The low tables go up to 8k only, and the scale is different.
Posted: Mon Jun 25, 2007 11:22 am
by jordancivic
Right click, delete.
Delete the lowest value on the rpm and it'll create another on the high end.