Page 1 of 1
Full Throttle Shift wiring
Posted: Sat May 26, 2007 11:13 am
by deafy
Hi,
I have a 97 prelude with p72/s300. I'm going to be using the SCS wire for FTS. My question is, which wire off the clutch switch do I use? Do I splice into it or cut it then wire to ECU? I've searched already, no luck. Thanks.
Posted: Tue May 29, 2007 11:15 am
by Spunkster
You must cut the wires. One goes to ground, the other goes to the input you specify.
Posted: Tue May 29, 2007 11:34 am
by jew
will doing this mess up cruise control?
Posted: Tue May 29, 2007 12:12 pm
by Spunkster
yes, just jumper the 2 wires that go to the cruise control unit together.
Posted: Tue May 29, 2007 1:55 pm
by deafy
awesome, thanks for the help.
Posted: Tue May 29, 2007 6:58 pm
by deafy
If both wires are snipped on the clutch switch, wont that prevent the car from starting? From what I read out of my shop manual, this is one of the components needed in order to complete the ignition circuit. This is for a 1997 prelude.
Posted: Wed May 30, 2007 9:25 am
by Spunkster
THere are 2 switches, the cruise switch and the interlock switch. You are only touching the cruise switch. The cruise switch disengages as the pedal is pressed down, interlock is engaged when the pedal is fully depressed.
Posted: Wed May 30, 2007 3:23 pm
by deafy
Now I see the other switch. It all makes sense. Thanks for the help!