Page 1 of 1
fuel suddenly goes very lean!
Posted: Sun May 13, 2007 11:02 pm
by garagelife
all my calibration suddenly goes very lean ? i add 80% at overall fuel trim then only the fuel gets right.....why? and i'm having problems to start the engine too....need to crank few times....
Posted: Mon May 14, 2007 8:23 am
by Hondata
Posted: Tue May 15, 2007 2:30 am
by garagelife
if i turn off my OBDII ......will it cause any problem ?
Posted: Tue May 15, 2007 2:37 am
by garagelife
i dont why the FTP got problems or not ...? when i turn on OBDII ,FTP sensor shown -8.4 and not moving at all.....even when i'm driving the car......
Posted: Tue May 15, 2007 9:23 am
by Spunkster
When posting a KPro problem with your vehicle, please include:
- the calibration (as an attachment)
- a datalog of a problem (as an attachment)
- what sort of vehicle you have
- what sort of ECU you are using
- anything about the car which has been modified from stock which may affect the ECU (don't include what sort of rims you have nor stereo etc).
- a specific description of the problem
Most of the recent posts leave out information pertinent to solving the problem.
If you have an engine swap, please mention this. There are known problems with the engine harness from one company, which they refuse to acknowledge or fix. We cannot name the company, but I always have used Hasport engine mounts and both their mounts and harness work.
Posted: Sat May 19, 2007 8:51 pm
by garagelife
sorry dudes, i found out is my fuel filter problems ......thanks a lots ...