Hondata

Posted: **Wed May 09, 2007 9:22 am**

Ok i basicly just want to know if this will work the way i want to wire this please help me out here....

Going to wire my radiator fan to the nitrous/aux input/output

arming input set to always on?

output im going to use pin A20 purge control

now do i need to use a relay to ground, i planned on using a switched 12v power source wired directly to fan and the output wired to the ground side of the fan do i need a relay inbetween ecu and fan for ground?

Posted: **Wed May 09, 2007 10:55 am**

also is there a way to run off the wastegate spring only and then have low/high boost switch as well

Posted: **Wed May 09, 2007 1:54 pm**

What exactly do you plan to control with this setup?

Posted: **Wed May 09, 2007 2:02 pm**

The radiator Fan...

Posted: **Wed May 09, 2007 3:31 pm**

Your radiator fan should be controlled by the thermo switch in either the radiator or the thermostat housing.

Posted: **Wed May 09, 2007 3:37 pm**

i know this, but it would be nice if i wired it up so i can adjust when it comes on....catch my drift...im just wanting to know if the ECU is capable of grounding that thing without a relay??

Posted: **Wed May 09, 2007 5:03 pm**

You should always use a relay when trying to activate solenoids and fans or anything that requires any amount of current.

Posted: **Fri May 25, 2007 11:46 pm**

I think the S300 should come with a fan control option.

Hondata

Fan control will this work?

Fan control will this work?