Hondata

Hello..
sorry for my bad english..i'm italian!
i have a problem with my euro civic type r pra ecu!
when i disable obd II for don't see the mil on (i have a race header), the car some times go blows...
i post the datalog..see the ignition, map, inj oscillate...up and down...
With the same kal...but with the obd II enable the car don't have the problem!!!

If you need to disable the P0135 error then this signals that there is a problem with the o2 setup.

What happens if you enable P0135? Check the o2 sensor wiring as per the factory manual, then try another o2 sensor.

you think the problem is on the first o2 narrowband sonde?
the problem of blows i have it with about 80 kpa map..when the ecu go in open loop or stay in close loop...!