ATTEN HONDATA EXPERTS - :)

[vtecsux]

Ok - I am a UNIX Systems Engineer by trade, where I command the respect of my peers/colleagues w/out trying on UNIX forums. However, when it comes to Hondas - well, I know enough to get me in trouble - ** smiling** . I am not green, I have some fairly serious street Hondas - but when it comes to tuning/ECUs, I am still learning. I've always been more of a "wallet -racer" - drop it off, and pick it up when it's fast - ha ha. I am trying to remedy that though. I have a few questions.

* 91 Civic Si HB
* OBD0 B16A3
* Hondata + PR3 ECU (USDM) :(

I know I have to do the OBDI conversion, I have the dizzy from RPMPARTZ already, and the OBD0 - OBDI harness. All I need is a p28 socketed for Hondata.

- Today I got a 2nd 02 welded and wired up (Zeitronix wideband). I still have the primary narrowband plumbed as well. How do/should I wire these for the s300? Do I have to use both signals, or can I eliminate the narrowband? Is there an advatage/disadvatage to running them both or running just the wideband? Also would there be a reason for me to replace the primary 02 to a wideband as well?

- Right now Hondata offers the s200 - s300 upgrade. Will this apply to my pr3 setup? If so - will I need to mail the pr3 and s200 in, just to have them send me the pr3 back since it's OBD0 and not supported? ORRR should I wait until I source a Hondata-ready p28 to send in?

Thank you very much.