Page 1 of 1
USDM on JDM
Posted: Tue Apr 03, 2007 11:52 pm
by Javcolin
Is it posible to use a USDM ECU on A JDM car?? cause i got the US ECU instead of the Square one for JDM will it work??? Thanks
Posted: Wed Apr 04, 2007 9:47 am
by Spunkster
They are interchangeable, just make sure you get the correct s300 for the ecu you have.
Posted: Mon Apr 09, 2007 9:22 pm
by Javcolin
Thats good. now what calibration should i use. Stock JDM P30 or Stock USDM P30. since the engine is JDM or it doesn?t matter wich one to use?? thanks for all your help
Posted: Tue Apr 10, 2007 10:02 am
by Spunkster
It is completely up to you what calibration you start with. You just need to make sure you disable the sensors that your ecu does not have.
Posted: Mon Apr 16, 2007 1:58 am
by Javcolin
Thanks for your help, now how do i know which sensors are the ones my ECU doesn?t have??
Thanks again
Posted: Mon Apr 16, 2007 11:27 am
by Spunkster
You will get errors immediately if it does not have the sensors. Usually, ELD, BARO, Fuel Injector Error...etc.
Posted: Wed Apr 18, 2007 8:44 pm
by Javcolin
Thank you very much. you have been very helpfull.
Javier