Page 1 of 1
cel but no codes
Posted: Fri Feb 16, 2007 12:17 pm
by p3t312
ok im having this wierd problem. i have a 28 and s200. im getting a cel but then when i check to see what the cell is. it gives me just a solid light. the red light in the box is solid.
Posted: Fri Feb 16, 2007 1:18 pm
by Spunkster
Are you checking the code by datalogging?
Posted: Sat Feb 17, 2007 5:00 am
by p3t312
datalog and jumping it
Posted: Mon Feb 19, 2007 10:41 am
by Spunkster
HAve you tried the reset procedure listed in the installation manual for the interface box? Check to make sure you don' thave a really low shift light set.