Page 1 of 1
Any chance Hondata will have more RPM and load points??
Posted: Sun Dec 03, 2006 6:06 pm
by TurboLS
Basically, I am designing a custom valvetrain and I need to have more quantization points for fuel and ignition values across the map. I know I can do this in load by using the boost tables and changing the values, but that's kind of using them for a different purpose, and only solves half the problem. If you could shed any light on this, that would be awesome.
Posted: Mon Dec 04, 2006 10:56 am
by Spunkster
If this is an LS, then set up VTEC and use the high and low cam tables.
Posted: Mon Dec 04, 2006 11:24 am
by TurboLS
and i guess i would just wire a signal to the VTP switch when i want the maps to switch, correct?? Are there any other considerations I should be aware of???
Posted: Mon Dec 04, 2006 1:29 pm
by Jaker
Just disable the VTP error code, and set the Vtec point where you want the maps to switch. The ECU will never know the difference.
Posted: Mon Dec 04, 2006 3:21 pm
by TurboLS
and by VTEC point, you mean RPM, correct?? thanks for the help.
Posted: Thu Dec 07, 2006 5:16 pm
by Jaker
Yes, RPM.
Posted: Sun Dec 10, 2006 8:35 pm
by QUICKSILVER RACING
you can also add more load points by activating the secondary tables.
10 more columns for your tuning pleasure.