Page 1 of 1
Good lunch with K pro help
Posted: Fri Dec 01, 2006 9:20 am
by Redliner
Hi! Just wanted to ask if it is safe to set minimum speed for VTEC operation @ 60kph for not to switching into high cams on the 1st gear for good start, and go for 2nd gear and high cam start to operate?
Thanks.
Posted: Fri Dec 01, 2006 10:31 am
by Spunkster
You can try it, but you don't want to rev as high on the low cam.
Posted: Fri Dec 01, 2006 3:48 pm
by Redliner
Yes, I know the peak power will like @ 7000RPM, but the main question is it safe?
Posted: Sun Dec 03, 2006 3:09 pm
by Razathorn
Redliner wrote:Yes, I know the peak power will like @ 7000RPM, but the main question is it safe?
Unless hondata will correct me here, I would think that is unsafe to operate the motor off vtec above 6500 rpm, regardless of speed.
Posted: Mon Dec 04, 2006 7:52 am
by Redliner
The point is that you shift @ 7500 and it drops bellow 6500 for sure, so it's fine to switch into high cams.
But the second gear will 7500 and high cams are switching, what that will be?