Hondata

I am running JDM B16A 2nd gen Engine with JDM OBD1 P30 ECM, I am planning to go for Hondata S300J for Boost, with a new feature of Boost control from the ecu which can be used only on USDM ECU since JDM ECU does not have circuitry to modify for boost control, can i use a USDM P28 ECU with Hondata S300 & Boost control option to run on an JDM Engine? will it work ? I want to compare P28 US & P30 JDM Codes for refrence.
any clues ? I want to use boost by gear feature on S300 with boost control.

Thanks in advance
Jitu

should be no problem.

just load your tuned calibration to your new ECU.

If you load the calibration into a US or JDM ECUs they will run the same. We have noticed a slight difference in the idle control circuitry, but the fuel, ignition etc will be the same.