Page 1 of 1
Kmanager Temperature Compensation Unit
Posted: Sun Oct 22, 2006 11:54 am
by Vincent
I would like to find out if the temperature compensation measurement unit is always using fahrenheit. Is it possible to be changed to celsius?
In my sensors setup for ECT & IAT, I am using celsius. Currently using the latest version of Kmanager v1.2.2.0
thanks
Posted: Sun Oct 22, 2006 6:08 pm
by Razathorn
Generally speaking, you shouldn't have to modify the temperature compensation tables unless they are different than those in the coldair calibration. Even on boosted setups, the provided temperature compensation tables from the coldair calibration are very good, and if anything, a tad bit richer when it gets freezing cold out.
Wayne
Posted: Mon Oct 23, 2006 3:22 pm
by Hondata
Changed for the next version.
Posted: Sat Dec 16, 2006 3:08 am
by Vincent
Reviving the thread, since the new version was release but under the release notes there are no mentions about this particular change.