1st time KPRO datalog

[eklover]

Well first off, here is my setup:

KPRO with 1.2.1.9 software
K20a2 motor bored and honed, Type R pistons oversized 86.25mm, balanced & blueprinted engine assembly, Hondata IMG, RC 440cc injectors, AEM sri, Comptech Shorty header, '05 RSX Type S Cat and midpipe, ACT clutch and lightened flywheel, 6-spd Trans w/LSD, and NGK Bkr 7e sparkplugs, 3 angle valve job on the head. I have about 750 miles on the motor now... :)

I just downloaded KPRO onto my laptop and did some data logging today. A few things I noticed that are not good, the knocks and the AF. It was constantly at 11.37 or thereabouts... I do hear knocking when I accelerate and I set the MIL light to come on when it senses knocks and its like a strobe light at night... I do pump 91 octane.

The 1st .kdl is acceleration from 1st-3rd on a street under "normal driving"
The 2nd .kdl is onto the freeway @ WOT from 3rd-5th gear
The .kal is the setup currently uploaded into the KPRO. It was put there by the shop who built the motor. I definitely want to take it to Church auto to get tuned in the very near future, but any help now would be even better!

I am new at this and have been reading up a lot but I figured I would like as much help from the people with experience as well. So thanks in advance! ~Matthew