Hondata

what wires go where to hook up the 2step and FTS. im tryin to use the clutch switch.

It all depends on how you are setting it up. You need to run the wire from the switch to the input on the ecu that you select in the software.

i put a switch where cruise conrotol would be. i know one wire goes to the ecu and where does the other one conect too. and the FTS hooks up to that same switch right

one wire goes to ground, the other goes to the ecu

is it ok to use the existing cruise control switch and just add another wire run over to the ecu? no relays or anythign involved?

thanks

YEs you can use the existing switch, but there is no need for relays as all you are doing is grounding the input.

thanks

I cant seem to build a lot of boost (maybe 2-3psi) I've tried different settings with the fuel enrich and ign retard but same thing. The only way I can get it to build boost is if I pre-load

I also noticed that the revs are far apart, is there any way to shorten the revs? It doesnt crackle or pop like I hear with other 2steps or antilag setups... maybe I'm lacking MSD or other things?

thanks

Denny

What RPM do you have it set to?

5-6k i've tried more or less same result?