Page 1 of 1
Posted: Wed Sep 13, 2006 8:44 am
by Hondata
Just use the default '5 Bar' setting. Switch the key on and check the MAP reading. It it is not atmospheric pressure, then check you wiring and/or MAP sensor. If you mis-wire a MAP sensor once, even briefly, it usually dies.
Posted: Wed Sep 13, 2006 10:29 am
by Silverbeast
5 bars work fine as with the S300 :)
Use the settings that he said and it wll work.
Posted: Wed Sep 13, 2006 2:36 pm
by BabyBhp
What would be the correct way to wire this in?
Posted: Thu Sep 14, 2006 10:30 am
by WickedCivicNY
wire it like you would a GM 3 Bar .. Signal/Power/ground