Display Option

Khuna · Post by **Khuna** » Sun Sep 03, 2006 10:48 pm

When my car was un-tuned, I ran off of someone else's basemap for like a day and the "Display" feature works perfectly. I noticed that after I dyno tuned, the "Display" feature didn't work properly anymore. The numbers freeze and they change periodically. I get DTC codes like crazy too. How can I get the "Display" feature to work again? I've already updated my version. The "Sensors" screen used to work too...now all the numbers freeze and change periodically.

Post by **Hondata** » Mon Sep 04, 2006 7:41 am

It sounds like it is not datalogging. If something other than your own laptop was used for the dyno tuning, it was probably with an older version of KManager.
Get the calibration that was used and upload it with your own laptop.

Khuna · Post by **Khuna** » Mon Sep 04, 2006 8:30 am

So just upload the calibration that was used right?

Post by **Hondata** » Mon Sep 04, 2006 10:00 am

Khuna · Post by **Khuna** » Mon Sep 04, 2006 10:04 am

Thanks! I got it to work but how come it only runs for like ten mins then feeeze?