Hondata

i have an S200 (with a base JRSC ITR chip) installed on my ITR with JRSC. i bought it with Boost and datalogging. well, i did a very quick datalog after the install just while the car was idleing. i used the datalogger and the ecu information in honbdalogger. it has all 3 options not installed (boost, datalogging and 3 step rev). the "ecu information" tab says the ecu serial number is S200-xxxx and when i select "upgrade" the dialog box appears with the serial number of the same, is this a bug? datalogging works fine (even though when i start datalogger while connected to the interface box i get the "datalogging has not been installed" error, but the car starts right up and i have no problems datalogging. I do still have yet to drive it and see if i get errors under boost. should i not worry about it or is this something i should call you guys about?

Remove J12 and the ECU Info should show up after you do that.

oops. forgot to add that the ecu is the OBDII connectorized P28 from hondata, so J12 was removed by them (i checked to make sure).

Call us and re-enter the unlock codes.

thanks Doug. turns out that i was using the "ECU Settings" incorrectly, attmepting to get the settings AFTER i had already "connected". everything's just peachy. thanks for getting back to me!!

Not Doug, but you're welcome.