Hondata

Posted: **Tue Jun 27, 2006 10:53 pm**

i have it set to show psi but it is only showing mbar can anyone help?

Posted: **Wed Jun 28, 2006 9:51 am**

Go to Options, settings, then go to the units tab.

Posted: **Wed Jun 28, 2006 5:01 pm**

ive done that and it still says Mbar in the upper right corner when im in positive pressure are of the map so does it always display the vacum units and never the boost?

Posted: **Mon Jul 24, 2006 10:03 pm**

anyone?

Posted: **Tue Jul 25, 2006 9:15 am**

To see boost tables, click on Options and Show boost tables.

Posted: **Thu Aug 07, 2008 9:11 pm**

I have the same problem, I changed the units to psi on the settings window and then selected the show boost table but still cant get the table to show psi values. This might be a dumb question as only one thread appeared on the search, but can somebody let me know how to change the units form mbar to psi on the table?...smanager version is 1.3.6.0.

Thanks in advance!

Posted: **Fri Aug 08, 2008 9:22 am**

Go to Options, Settings, Units.

Posted: **Mon Aug 11, 2008 5:33 pm**

Upperguy wrote:i have it set to show psi but it is only showing mbar can anyone help?

Do you mean when youre viewing a datalog ? I am having this same issue . Whenever i review a datalog it always shows in mbar instead of psi . Perhaps someone can chime in and help ?

Posted: **Mon Aug 11, 2008 8:30 pm**

options

settings

then click units. its the 2nd tab.

then in vacuum pressure the first box,

click "inch"

go to the next box pressure unit,

click "Pounds per square inch (psi)"

then click "ok"

be sure in the other box "vacuum unit base"
click absolute(increase from full vacuum)

"pressure unit base"

click "Atmoshperic (atmoshperic=0)

i think that should solve your problems, if its not your not doing something right

Posted: **Wed Aug 13, 2008 4:01 am**

I must have something wrong here...can someone tell me (check the print screen)...I can't see the table in psi after the changes in the settings tab. Thanks again!

Posted: **Wed Aug 13, 2008 9:26 am**

They must both be atmospheric, not absolute.

Posted: **Sat Aug 16, 2008 11:53 am**

Still can't...I can only see vaccum on the boost tables, Does it has to be online for it to show psi?....Thanks for all the help.

Frankie

Posted: **Sun Aug 17, 2008 5:11 am**

yakito wrote:Still can't...I can only see vaccum on the boost tables, Does it has to be online for it to show psi?....Thanks for all the help.

Frankie

Agreed , im in the same boat .

Posted: **Mon Aug 18, 2008 7:23 am**

Please post you calibration. It is possible that the columns have been re-calibrated to not have any boost columns.

Hondata

how do i get psi to show in the table ?

how do i get psi to show in the table ?

Same problem - help please!

Re: how do i get psi to show in the table ?

Still Can't

Not yet!

Re: Not yet!