Page 1 of 1
D16Y7 noob install question
Posted: Fri Jun 02, 2006 8:18 am
by SOHC_STUDENT
Hey,
I've got a P28 w/ S300 ready to plug into my D16Y7.
Looks like the stockp28 calibration is the closest one in there for my engine.
Can I adjust the injector size down to 190, disable vtec and use it?
Posted: Fri Jun 02, 2006 9:16 am
by Spunkster
It is a fully adjustable system. You can make whatever changes you like to the calibrations.
Posted: Fri Jun 02, 2006 12:56 pm
by SOHC_STUDENT
Here's what I'm getting at...
Will this config run my car well enough to start it up and get a reading from my wideband sensor and make adjustments from there?
Posted: Mon Feb 19, 2007 12:00 pm
by cree
SOHC_STUDENT wrote:Here's what I'm getting at...
Will this config run my car well enough to start it up and get a reading from my wideband sensor and make adjustments from there?
i'm in the same proverbial "boat." i did a search, and this old thread is what i came up with. anyone know which adjustments would need to be made other than disabling vtec? ..or possibly some guidance for this noob?