Hondata

I?m running the s300 on my car, but from time to time it seems the software forgets the defined target lambda and goes back to its original values, is this a bug or something?

Can you be more specific and post calibrations and datalogs?

for example i set target lambda to 14.7 low load, 13.2 medium load and 11.8 high load, and after loading the map a few times it goes back to the pre defined values ( 14.7 / 13.5 / 12.5 )

Can you give a sequence of operations which will reset the values?

it happens after i start the s300 manager a couple of times and load the map im tuning, lately havent had any issues though (not that i can call that an issue)