Page 1 of 1
wideband sensor bosch
Posted: Mon Feb 13, 2006 6:20 am
by contectr
Hi..
i have a euro civic type r with kpro!
can i connect the bosch wideband sensor code 0 258 006 066 for datalog the voltage a/f ratio?
Posted: Mon Feb 13, 2006 11:09 am
by Spunkster
No you cannot. The PRA ecu can only us a narrowband sensor. To be able to use a wideband you must use the PRB US ecu and the stock wideband sensor from a US RSX (02-04).
Posted: Tue Feb 14, 2006 2:01 am
by contectr
but in the new version of the kmanager is not possible with aem uego?
Posted: Tue Feb 14, 2006 4:27 am
by CivicVTi
You can actually use a wideband to datalog BUT you have to use its controller (eg the AEM or PLX or Innovate unit etc). In order to feed wideband signal directly to the ECU, you have to use the PRB ECU and stock US wideband.
Posted: Tue Feb 14, 2006 9:02 am
by contectr
ok...
where i can buy this kit for italy?
Posted: Tue Feb 14, 2006 10:11 am
by Spunkster
CivicVTi wrote:You can actually use a wideband to datalog BUT you have to use its controller (eg the AEM or PLX or Innovate unit etc). In order to feed wideband signal directly to the ECU, you have to use the PRB ECU and stock US wideband.
This is incorrect. This can only be done with teh SManager software. This will not work with the K-Pro as it uses a different type of wideband. IT does not measure voltage, but current instead.