Hondata

Hi guys
Noob here
any ways planning engine build B18C4 etc and was wondering if the base maps included in the software were 100% or near as pos to the original Honda maps and are therefore perfectly good for a standard engine, did have a search but didnt answer my question completely

the plan is to build up the engine, run standard for a few miles to run it in on a completly standard map, then start playing with nitrous then boost etc, im going fully programable now so that it is done and out the way and there for as soon as im ready

thanks for the help
WEST

They are as close to stock as possible.

Spunkster wrote:They are as close to stock as possible.

just what i wanted to hear. thought they would had been just wanted to make sure before i get too indepth as im looking into maps etc at the minute and havnt the engine ready yet dont want to waste my efforts sure there will be more head scratching later

thanks for the help

Cheers

WEST

where can i find the stock honda maps for the s200? i'm looking for stock honda map for a d16z6. thanks

They are in Romeditor. File, new.

i know this is a huuuge thread revival but what map is the standard map for this engine. i keep searching but havent come up with the specific answer

cheers

which engine?

Spunkster wrote:They are as close to stock as possible.

Compare the ignition on the stock ITR with the stock B16 then :?

sorry it was the b18c4

Just use the stock ITR one that's there.
Compare the ignition to that of the LsVTEC one and make up your own mind on what you think suits the car best.