Hondata

this may sound stupid but im barely geting into tuning. i have a non vtec ls motor and i want to tune it my self, so that i can learn. on the smanager it says low speed fuel and ignition and than high speed fuel and ignition. from reading on this website and tutorials, that is for a vtec engine high speed fuel would be after vtec and low speed would be before vtec. since i dont have vtec should i only be tuning the high speed or low speed tables or make them both the same. IM confused please help.

Welcome to the forum! You should only be tuning on the low cam tables, unless you have a need for more resolution and higher rpm..

Good luck, and be careful when using the ignition tables, that is an easy way to damage a perfectly good motor..

thanks for the awnser now i understand it better

locash wrote:Welcome to the forum! You should only be tuning on the low cam tables, unless you have a need for more resolution and higher rpm..

Good luck, and be careful when using the ignition tables, that is an easy way to damage a perfectly good motor..

Listen to Locash...he's the man. :) Also, it's best you don't mess with the ignition tables until you know what you're doing.

Good luck learning.