Hondata

Posted: **Tue Jan 17, 2006 5:58 am**

Hello!
I just received the S300, could someone help me to get the Civic D15Z6 /EDM/ engine's original basemap?
It is actually OBD2B, but the new control is OBD1 /P28-ECU EDM 5 speed manual + Hondata s300/. Could someone help me how to run / operate it? I have only found D15B in the program.
Thanks!

Posted: **Tue Jan 17, 2006 10:29 am**

You cannot put an OBD2 program into an OBD1 ecu. You will have to start with the p28 calibration and tune form there.

Posted: **Tue Jan 17, 2006 12:52 pm**

Thanks, i will try it.

Posted: **Wed Jan 18, 2006 2:04 am**

Could someone help me find an ignition and fuel-air chart with factory settings for my engine?

Posted: **Sat Feb 04, 2006 1:45 pm**

Would you please let me know which ROM should i start using with my s300 if I only have a lambda /sensor/ or o2 with 1 wire ? /not 4 wire/
because my ECU said error code 41 Primary oxygen sensor heater.
thanks

Posted: **Mon Feb 06, 2006 10:36 am**

a 1 wire o2 sensor will not work with an OBD1 ecu. You will have to purchase a wideband if you want to get wideband readings (such as the PLX). To run properly in closed loop with a stock sensor you must be using an OBD1 4 wire O2 sensor.

Hondata

Basemap D15Z /edm/ ?

Basemap D15Z /edm/ ?