Hondata

Hi just a quick question for all.

If you vtec is engauging @ 6000rpm what should the axis rpm start @ for you fuel and ignition table???

common sensce would say start @ 5500 to 9000... why would you start it @ 0 then 600rpm becuase your never going to be in vtec below at least 4000rpm.

Whats everyone think??

Hondata??? any advise???

Thanks

any1 :(

each cam (low and high) has their seperate ignition and fuel maps. judging by the 600rpm you said i'm assuming you are just looking at the low cam tables.

Sorry i meant on the high speed fuel and ignition map can i set the axis on the left to start @ 5250rpm upto say 10000rpm instead of startiing @ 500rpm to 8950rpm see screen shot.

The reason i ask is becuae my vtec is coming in @ 6000rpm so below that the high speed map wont be doing anything

Yes you can do that.

would you recommend doing it this way??