Page 1 of 1
B18C type R boosted with S300...need help
Posted: Sat Jan 07, 2006 12:03 am
by shobee
I am new to using hondata or any ecu editor. here is my setup:
B18C type R with wiseco 9:1 pistons
crower rods, block gaurd, 1:1 fpr, 550cc injectors, KKK k26 turbo, Apexi GT front mount intercooler, Arp bolts. I plan to run 15 psi boost (max).
I am running S300 on a P28 ECU with OBD1 wiring
Boost kicks in at around 3500rpm and full boost at 3900rpm.
I need base maps of similar setups so that with minimum fine tuning I can have safe and decent power. Any help in this regard would be much appreciated.
Posted: Mon Jan 16, 2006 9:49 pm
by kaj
you can find a base map, but i would NOT count on it being safe... only being good enough to get the car to a tuner :!:
Re: B18C type R boosted with S300...need help
Posted: Wed Jan 25, 2006 8:22 am
by cinq
shobee wrote:I am new to using hondata or any ecu editor. here is my setup:
B18C type R with wiseco 9:1 pistons
crower rods, block gaurd, 1:1 fpr, 550cc injectors, KKK k26 turbo, Apexi GT front mount intercooler, Arp bolts. I plan to run 15 psi boost (max).
I am running S300 on a P28 ECU with OBD1 wiring
Boost kicks in at around 3500rpm and full boost at 3900rpm.
I need base maps of similar setups so that with minimum fine tuning I can have safe and decent power. Any help in this regard would be much appreciated.
Might want to get yourself a wideband. With that, atleast you can street tune it yourself, and at the same time, knowing what your true A/F is. Plus..it's you'll have a blast tuning it on your own. GET A WIDEBAND! :)
re:
Posted: Thu Jan 26, 2006 10:25 am
by tboostdsi
hey, i basically have the same setup. i have 9:4.1 ratio and a b18c5 w jrsc 8lb boost. 84mm bore. i just got the s300 and i need help as well. i do have the plx m300 though. have you got the wideband and the plx device yet? let me know how you hooked it up if so. the only thing i have to wire up now is the eld wire....i dont know what or where this is. if you have any questions to ask let me know.....
Posted: Thu Jan 26, 2006 1:44 pm
by shobee
hmmmm... thankyou all for the advice, however I have the innovate LM-1 wideband with complete ox box and stuff and I am tuning using it. I do not have a plx device so cant help you. I ran 9 pounds on the greddy file with minor changes, it ran ok. so u could start with that..