Page 1 of 1
S300 & JDM P30
Posted: Sun Dec 04, 2005 1:09 am
by mammad78
can i use my jdm p30 ecu with s300, if only the shape is the problem i can modifie it, cuase this is for a drag use only. i just want to know if the s300 supports jdm p30 board
thanx
Posted: Sun Dec 04, 2005 1:18 pm
by RMS
others have made it work, but i think you will lose some functionality so far as generic outputs are concerned.
Posted: Mon Dec 05, 2005 2:09 am
by mammad78
RMS wrote:you will lose some functionality so far as generic outputs are concerned.
thanx for your reply
what do you mean by that?
Posted: Mon Dec 05, 2005 2:12 am
by mammad78
RMS wrote:others have made it work.
how? is it the same steps that is mentioned in the hondata site
Posted: Mon Dec 05, 2005 7:17 am
by Dee
Did you ask this question Honda-Tech?
The case itself is the problem. You will need to do some hacking on the case to get it to work with a JDM P30. Your best option is trade the JDM P30 for a USDM P30. Joe at locash racing hooked me up with a USDM P72 since I could not use my JDM P72.
Yes, we've made it
Posted: Tue Dec 06, 2005 5:09 am
by Mura
you can make something like podium with few sockets. It's looks like podium using on S200 with Romulator. You should insert 2 male sockets to the upper level of this podium.
Also you should solder 4-pin socket by wires.
Sure, you could not to close the cover of ECU after this installation, but I think it would not a big problem for drag car )))