KManager v11 Bug
Posted: Thu Nov 17, 2005 7:22 am
I've noticed that when adjusting fuel on a .kal thats been opened for the first time, the fuel tables switch to a different cam angle after the adjustment.
Scenario:
- Open .kal with datalog already loaded.
- Make a change to any fuel at any cam angle higher than 0?
- Reopen the same or another .kal with datalog still open
- Make the same (or different) change to any cam angle higher than 0?.
The current view will change from the current angle to 0?. I think the change is made on the correct angle, but the switch from current view to 0? is confusing.
I've found the workaround is this solution:
- After opening any .kal, reselect current conditions by unselecting and selecting again (if in high fuel, switch to low and switch back, etc).
Thanks.
Scenario:
- Open .kal with datalog already loaded.
- Make a change to any fuel at any cam angle higher than 0?
- Reopen the same or another .kal with datalog still open
- Make the same (or different) change to any cam angle higher than 0?.
The current view will change from the current angle to 0?. I think the change is made on the correct angle, but the switch from current view to 0? is confusing.
I've found the workaround is this solution:
- After opening any .kal, reselect current conditions by unselecting and selecting again (if in high fuel, switch to low and switch back, etc).
Thanks.