Hondata

shouldn't the output activate if I zero RPM, TPS, VSS conditions when trying to use it toactivate a boost controller

the only time I can get the output to do anything is when I invert the polarity it goes to groun

nothing else seems to change what it is doing

doing same thing on both nitrous control outputs whether the engine is running is key just on

I need this boost controller to work for this weekend

Can you post the calibration you are using and post a datalog showing it not working with that calibration?

from what I noticed on the datalog between N1 and N2 u can't use 0 rpm, or 0 tps, 0 vss maybe because u aren't above 0 but at 0 to activate

N2 never activated with min rpm set at 0, that was the only difference in activating between the two

don't know how N1 got to 3000 min turn on it just keeps doing that on its own every now and then

would have had more datalogs but #3 sleeve sank .010" on that pull in our Darton sleeved block, will have it apart and redecked by friday hopefully so we can run this weekend

it seems to work while going down the track

ran 9.86@146 this weekend