98 Integra GSR-Turbo

98turbo · Post by **98turbo** » Thu Oct 27, 2005 5:33 pm

I need heelp! I recently purchased S300 Hondata with ECU P28 for my 98 turbo integraGSR. I am also new to this type of things. Can someone give me a hand and assist me step by step on getting it program to atleast make my car run. Your promtp response is greatly appreciated.

Silverbeast · Post by **Silverbeast** » Thu Oct 27, 2005 11:20 pm

Open up SManager. Click on Help, then click on Contents. Read and repeat.

mkulak · Post by **mkulak** » Fri Oct 28, 2005 12:18 pm

Silverbeast wrote:Open up SManager. Click on Help, then click on Contents. Read and repeat.

I'm sure he was looking for more help...

I'd start of with the B16 Greddy Turbo file and go from there... Tuning will be required, but it should get the car running...

b19coupe · Post by **b19coupe** » Sat Oct 29, 2005 8:31 pm

Here is a good GSR turbo basemap. You will just need to recalculate for whichever size injectors that you are running.

98turbo · Post by **98turbo** » Sun Oct 30, 2005 2:29 pm

Thank you guys for the responses. I finally got my car running with the calibration info and uploaded to my new ecuP28 as a replacement for my ODBII ECU (P72). So far, it's been okay but my question is why is it that my idle is so high even on normal temp of the engine? I know that i need to get it tune! However, i am not quiet ready for that path yet. Can someone help me once again and provide me info on how to refine my issue (high idle 1200-1500). I also made one changes on the calibration which is the size of the injectors (310cc).

B20CIVIC_1 · Post by **B20CIVIC_1** » Sun Apr 02, 2006 11:00 am

can you send that map to my email. b20civic_1@hotmail.com

98 Integra GSR-Turbo

98 Integra GSR-Turbo

Basemap