Setting up "Dual boost controller" with Nitrous/AU
Posted: Thu Sep 01, 2005 5:23 pm
Current Setup:
P28 Ecu with S300
Greddy Profec B (old version)
Perrin boost solenoid
Input: Always on (which meaning, everytime the motor met the conditions set, it would engauge the switch to the output)
How exactly do I wire the output?
P28 Ecu with S300
Greddy Profec B (old version)
Perrin boost solenoid
Input: Always on (which meaning, everytime the motor met the conditions set, it would engauge the switch to the output)
How exactly do I wire the output?