K Pro wont read my A/F in Dataloging?!!?
Posted: Sun Aug 28, 2005 1:32 am
I did my 1st Datalog today..and my A/F doesnt show up on the Download
But my Question is my A/F.
I do have a A/F Gauge hooked up and it reads it perfect.
Its hooked into my ECU E Connector..Its not the A/F Gauge..I tried to disconnect it and try it that way..
I do have a White wire in my Engine bay that the Gauge WAS connected to but never received a signal.
So I took it off and hooked it to the ECU. So now theres a singe white wire that goes into a connector that goes to the 02 Sensor (not sure which one)
Anyone know what that white wire goes to?
Can anyone help troubleshoot this?
Pic of White Wire:
http://tinypic.com/b7gga0.jpg
But my Question is my A/F.
I do have a A/F Gauge hooked up and it reads it perfect.
Its hooked into my ECU E Connector..Its not the A/F Gauge..I tried to disconnect it and try it that way..
I do have a White wire in my Engine bay that the Gauge WAS connected to but never received a signal.
So I took it off and hooked it to the ECU. So now theres a singe white wire that goes into a connector that goes to the 02 Sensor (not sure which one)
Anyone know what that white wire goes to?
Can anyone help troubleshoot this?
Pic of White Wire:
http://tinypic.com/b7gga0.jpg
