Hondata

My brother has a stock internally JDM B16, S200B, RC 440 Injectors, running a Rev Hard T3/T04E turbo at 7.25 psi. Until he welds up a wideband bung I cannot tune for A/F and fuel.

My question is, until he puts in a bung, what base pre programmed map should I run.. Currently I burnt him the "b16afmaxturbo9lbs-440-60-4500-B16A Fmax Turbo 9 lbs" map off the custom tables provided in Rom Editor... This map obviously has him running extremely rich in fuel causing the car to bog quite a bit.

Maybe this is for the Hondata people direct, but is there a better map I could use for his @ 8psi setup on 440 injectors??? Please let me know.. Thanks

anyone?

I would recommend just using a stock basemap adjusted for injector size and custom boost tables created under EDIT, CREATE BOOST TABLES.

can anyone tell me how much boost the "b16 440inj Greddy Turbo" map is based on located in the custom tables??

I do not recommend using the custom tunes, as they are old and very out of date. You could just start form a new map and create your own boost maps. This will require less adjusting and fixing when you begin tuning.