Changing the table index (load and rpm)
Posted: Fri Jun 10, 2005 10:23 pm
Hi all,
I noticed (some calibrations) has 500 or more rpm interval from 3000 to 5000 rpm. Would it be better if reduce to 250 rpm interval to be consistent across?
Similarly, for load, can I use the boost table (additional columns) and reduce the load for NA application? I can create more tuning points.
With more tuning points would it enhance the tuning or I'm better off relying on the pre-set calibration and ecu computation?
Thanks for any feedback.
I noticed (some calibrations) has 500 or more rpm interval from 3000 to 5000 rpm. Would it be better if reduce to 250 rpm interval to be consistent across?
Similarly, for load, can I use the boost table (additional columns) and reduce the load for NA application? I can create more tuning points.
With more tuning points would it enhance the tuning or I'm better off relying on the pre-set calibration and ecu computation?
Thanks for any feedback.