Page 1 of 1
Help! need conversion table zeitronix wb with hondata
Posted: Sun May 29, 2005 2:13 pm
by CTR88
all wires are soldered according to installation manual. datalogs perfectly with the zeitronix software. but i would like to use the romeditor software to datalog. i used the ar/volt readings that came with the wb but doesn't come close. my readings on hondata don't even move. reads like 10.xx when its really 14.7 on the zeitronix lcd.
please help. i have the output wire soldered onto to d14. its in open loop and o2 heater disabled. anyone else use it with hondata?
Posted: Tue May 31, 2005 10:20 am
by Spunkster
What is the voltage range of the wideband output?
Posted: Wed Jun 01, 2005 4:50 pm
by CTR88
according to there data sheet. its starts from 0.15v:9.7a/r to 3.27v : 21.2a/r
the readings are off by alot.
Posted: Thu Jun 02, 2005 8:02 am
by turbosi92
CTR88 wrote:according to there data sheet. its starts from 0.15v:9.7a/r to 3.27v : 21.2a/r
the readings are off by alot.
You need to create a custom table in the settings menu. If it still doesn't work, it is because this wideband doesn't not output a linear signal....aka AEM UEGO.
Posted: Wed Jun 08, 2005 6:27 pm
by CTR88
is it possible we'll see an update that will work with zeitronix in the future?
from zeitronix data sheet
Volt:|0.15|0.31|0.46|0.62|0.78|0.93|1.09|1.24|1.40|1.56|1.71|1.87|
AFR:|9.70|9.90|10.1|10.3|10.5|10.7|11.0|11.4|11.7|12.1|12.4|12.8|
Volt:|2.02|2.18|2.34|2.50|2.65|2.80|2.96|3.00|3.12|3.27|
AFR:|13.2|13.7|14.2|14.7|15.6|16.9|18.5|18.8|19.9|21.2|
Posted: Sat Jun 11, 2005 5:39 am
by kesnut