Setting 3-step when datalogging isn't enabled?
Posted: Wed May 11, 2005 9:11 am
One car i tuned recently had the 3-step option on his s200. on my car, i set the 3-step via hondalogger. Oh his blue box, since datalogging wasn't enabled we couldn't set the 3-step with hondalogger. So we did the button trick, one push then rev to launch rpm, etc etc.
well I find this method to be mildly inaccurate with holding a steady rpm & such. Likewise, our initial guess of launch rpm was too low. now when we try to adjust the launch rpm higher, by pushing the button once, reving to new launch rpm, hitting the break, restarting. The previous launch still stays there.
any help is welcomed.
well I find this method to be mildly inaccurate with holding a steady rpm & such. Likewise, our initial guess of launch rpm was too low. now when we try to adjust the launch rpm higher, by pushing the button once, reving to new launch rpm, hitting the break, restarting. The previous launch still stays there.
any help is welcomed.
