using three step
Posted: Sat May 07, 2005 1:59 am
is there a way i can disable the full throttle shift and just make use of the launch control?
Page 1 of 1
Posted: Sun May 08, 2005 7:04 pm
just set your full throttle shift to an rpm that is higher than your rev limit.
Posted: Sun May 08, 2005 8:21 pm
but the full throttle shift can only be set to 5t-8t right? it says on the manual..im changing gears at 9-9.5t 
Posted: Mon May 09, 2005 6:51 pm
I have mine set to about 10,500 and my rev limit is 8800
Posted: Tue May 10, 2005 5:56 am
great. i'll try it tomorrow..
i was planning to do that but the manual said that it can only be set from a certain rpm like 8000 or something....so i didn't try it..
i was planning to do that but the manual said that it can only be set from a certain rpm like 8000 or something....so i didn't try it..
Posted: Sun May 15, 2005 1:45 pm
What is your setup? I ask this because I'm wondering about the same thing for the full throttle shifting.
Posted: Mon May 16, 2005 7:06 am
b16a with LS crank. 185whp/130ft-lb.
with s200.
with s200.