Hondata

Is it possible to run open loop and go off fuel tables on low cam? I am boosted and have had to pull a bunch of timing on low cam to keep from knocking while climbing steep grade. Closed loop is pulling 20% fuel keeping afr at 14.7. I have the target lambda low afr 12.5 in column 9, but closed loop is holding afr at 14.7. Is there a setting I am missing that will fix my issue? Thanks

You have not said what vehicle you are referring to.

2009 Honda civic Si with Flashpro v4.5

Post the calibration and datalogs showing the issue.

Been a busy week...

I am guessing there is a setting somewhere I am missing so closed loop will go off my target lambda and wot lambda tables. Calibration file and datalog attached. Been street tuning over the last 4 months. Car was "tuned" by a shop in Atlanta originally and had all sorts of issues (locked to 10 degrees on low cam) so I took on the task of tuning it myself. Any help is appreciated!

Where in the datalog are you having the issue?

10:20 to 11:00 is a specific example where I'm in column 9 13.07afr requested target lambda low and afr is holding 14.7afr. 39% throttle. Why is it holding 14.7 instead of requested? In attached data log above. It is weird because you can see the afr richen up after a few seconds.

It appears to be following pretty closely to what is requested in that time range in the datalog you have posted.