Injectors Duty Cycle issue
Posted: Thu Sep 11, 2025 5:00 am
Hello all,
I have an issue in my Tune , when i press fast sudden Wide Open Throttle my car bucks and then continues acceleration and afr is too rich, when i checked the datalog i found that the injectors open 16ms at the time of rich spike then goes back to 9ms till the end of the pull like maximum 12ms and the issue is i changed TPS, Map sensor and same issue happens, Specially if i am at TPS 0% to 25% if i press from 26% it won't cause the issue of the buck or rich 9 afr, even if it was so fast, also between gears same issue happens of course..
the thing i have noticed also i want to add as a NOTE : When i was cruising if i press TPS 1% duty cycle is 1% if i pressed 5% duty cyle gets to 5% and like it is linked to it and takes the same Value exactly till 23% and after that its back to normal, i changed the tps/map sensor and same issue happens.
My Setup: D15B7 Mini Me with Injectors 240cc High Impedance 12v and all wiring's are very good and grounds are good i even used 2 extra ground wires to the distributor and one from the negative terminal to the chassis.
Any ideas what could be the issue?
I have an issue in my Tune , when i press fast sudden Wide Open Throttle my car bucks and then continues acceleration and afr is too rich, when i checked the datalog i found that the injectors open 16ms at the time of rich spike then goes back to 9ms till the end of the pull like maximum 12ms and the issue is i changed TPS, Map sensor and same issue happens, Specially if i am at TPS 0% to 25% if i press from 26% it won't cause the issue of the buck or rich 9 afr, even if it was so fast, also between gears same issue happens of course..
the thing i have noticed also i want to add as a NOTE : When i was cruising if i press TPS 1% duty cycle is 1% if i pressed 5% duty cyle gets to 5% and like it is linked to it and takes the same Value exactly till 23% and after that its back to normal, i changed the tps/map sensor and same issue happens.
My Setup: D15B7 Mini Me with Injectors 240cc High Impedance 12v and all wiring's are very good and grounds are good i even used 2 extra ground wires to the distributor and one from the negative terminal to the chassis.
Any ideas what could be the issue?