Hondata

FlashProManager 4.4.9 (15 May 2025)

• Firmware updated to version 262
• Fixed TSX/RDX not detecting ECU

Download here

just found out some of my preview mapping cannot upload because the software changed calibration from US to middle east , or from japan to Middle east also, i try to change the location and upload but the mapping crash, car doesn't run good,please check

thanks
KL

updated 4.5.0.0

Open the file was tuned with US, now auto changed to Middle east same as 4.4.9, i change location to US and save it, reopen now it is Japan.

please check again thank you!
KL

You'll have to tell me what vehicle model you have, if you are doing this with the flashpro plugged into the laptop, and what the calibration is (post it here).

This is the map start tune with US FL5 and now calibration auto changed to Japan
no flashpro plug in, just open from my files

Seems fine for me. Can you run through step by step what you are doing and where it goes wrong?

like this map it is Japan FL5 was saved and using long time, now we open it and auto changed the location to middle east

That calibration was saved as a Middle East model. Change to US, save and then it will show as US.