Hondata

So i just changed my motor mounts and TPS and was putting everything together. I hooked the wrong plugs up on my skunk2 74mm TB. Had the key on and was going to calibrate my TPS and noticed. I hooked the connectors to the right plugs calibrated the TPS but noticed the MAP was reading -28.8psi. The car will not start now. I'm guessing I fried the map sensor. Would this be a good assumption or am i missing something? The car was running just fine prior just bad motor mounts that caused the TPS to get smashed on the firewall.

Current Setup

98 Honda Accord Sir-T CF4
g series 6255 51r mod
KS pistons/rods 10:1
Skunk2 74mm TB
Skunk2 Intake
FIC 1000cc injectors
p28 Hondata s300

IF it is plugged in correctly and still not reading correctly then it was probably damaged by having it wired incorrectly.